Parts & Accessories
Prestacycle redesigned the Presta Grommet in May 2012 to fit to modern standards. PRestacycle's design works so well, it’s been copied by others including major floor pump makers. Prestacycle's design engages the Presta valve just below the cap threads and requires less insertion. The head is now very easy to get on and off, and gives a nice “click” feeling when it’s installed in the right position. Safe for all types of Presta valves, including tubeless and tubeless-conversion valves. Will not harm newer lightweight performance valves. Fits all Prestaflator BIG Push/pull Presta heads. Also fits all Silca pump heads that use the 24.1 or 242 Gasket.
Renew all the seals in your Prestaflator spin head. These o-rings fit the seals, Plus there are five (5) Presta Valve replacement washers. Replace as needed for a good connection to your tire valve.
$4.95 - $5.95
Prestacycle's newest version of the Presta Head Gasket uses Urethane Elastomer. It’s softer and stronger. It lasts more than 5 times longer, gives a better seal and flexes to work anywhere along the Presta shaft for better tubeless tire application.
Use it to upgrade your floor pump or tankless electric inflator to use Prestaflator heads and accessories. Made with 6061-T6 Alloy – Strong as Brass and only 1/3 the weight. Hose clamp not included. The correct hose clamp varies based upon the outer diameter of your pump’s hose.
Upgrade your heavy Brass or Steel coupler. Made with 6061-T6 Alloy – it’s as strong as Brass and only 1/3 the weight. Less weight in your hand means you can focus more energy on your work. Coupler weight 31 grams, compare to around 100 grams for Brass or Steel. I/M (Industrial / Mechanical) standard sizing will also fit your existing I/M connectors. CNC machined with stainless steel bearings and a nice polished finish. Kit option includes coupler plus three male plugs and one female plug.
Braid-reinforced PVC hose is stronger than Prestacycle's original Black hose from a few years ago, and also twice flexible! Schrader Spin-on head accepts all Presacycle Head, new and old. 200 psi working pressure, 13 inches length. Uses standard 1/4" threads. Non-marring and resistant to moisture, fungi, oil, fuel, and grease as well as abrasion, impact, and tearing. Operating temperature range is from -30° to +125°F. Fits all previous Prestaflator tools, o-ring included.
- Allows you to upgrade floor pumps to accept Prestacycle attachments - Spin-On presta head with pressure release option, USA-made 36" hose and hose clamp are included
Coil hose made is USA is superior to imported coil hoses. Rated for high pressure and durability. Brass swivel ends on both ends of the hose. Standard 1/4” NPT threads. Narrow hose increases strength and reduces waste when using Nitrogen. Short length hose recommended when your inflation source is close to your work or is portable and is usually moved to your work. Great for Nitrogen and small portable Air Compressors. Vibraseal coated threads, no thread tape or sealant needed!
Page 1 of 1